Sometimes the concrete is already there and you need to get through it. Saw cutting makes straight, clean cuts in slabs and walls, and core drilling makes round holes from small pipe penetrations to larger openings. We provide both for homeowners, plumbers, electricians, HVAC installers and general contractors in Brighton, Ann Arbor, Milford and the Lansing area.
Common jobs include cutting a new doorway or egress opening in a foundation wall, trenching a basement floor for drain lines, removing a damaged section of driveway, and coring holes for plumbing, electrical conduit, dryer vents and HVAC lines.
Cutting and Coring for Michigan Homes and Buildings
Many cutting jobs here are tied to the climate. Homeowners add basement egress windows, run new sump and drain lines to deal with wet clay soils, or replace frost-heaved and salt-damaged slab sections without tearing out a whole driveway. Clean cuts matter because a straight, square edge lets new concrete tie in neatly. We use water to control dust, protect nearby surfaces, and check for buried utilities before cutting.
Michigan conditions create plenty of reasons to cut concrete. Sections that have heaved from frost or settled over soft clay can be cut out and replaced without tearing out an entire slab. Basement floors are often cut to add drains or sump pits that help keep water out during wet springs, and garage floors may need trenches for new plumbing or electrical. Wet cutting keeps dust down and gives clean, straight edges, which makes patch work look neater and helps the new concrete bond properly. Before any cut, we talk with you about what lies under the slab, such as pipes, wiring or radiant heat lines, so nothing is damaged along the way.
Our Process, Step by Step
- 1
Mark the layout
We confirm the exact location, size and depth of each cut or hole with you or your trade partner.
- 2
Check for hazards
We look for buried lines and reinforcement, and arrange utility locates when needed.
- 3
Set up and protect
Plastic, water control and barriers keep slurry and dust contained.
- 4
Cut or core
Diamond blades and core bits make clean, precise openings.
- 5
Remove and clean up
Cut pieces are removed and the work area is cleaned.
Options Available
Slab saw cutting
Driveways, garage floors, basement floors and sidewalks.
Wall sawing
Door, window and egress openings in foundation walls.
Core drilling
Round holes for plumbing, electrical, vents and anchors.
Trench cutting
Narrow cuts in floors for new drain or water lines.
Frequently Asked Questions
Is cutting concrete messy?
Wet cutting creates slurry instead of airborne dust. We contain it as we work and clean up when finished.
Can you cut a doorway in a basement wall?
Yes. Openings in load-bearing walls may need a header or engineering, so we will talk through that before cutting.
Are you insured for this kind of work?
Yes. We are licensed and insured, family-owned, and have over 10 years of experience with concrete.